Mark One Firmware Update is Live: More Reliable Fiber Printing
Today we released an update for your Mark One 3D Printer which includes the new Adjust Fiber Prime Length utility.
Using this utility will improve your success rate with fiber prints because it tunes the Mark One better for fiber variations. It will mostly improve the performance of continuous carbon fiber printing, but also adds some support for Kevlar TM and fiberglass composite printing.
After you’ve updated your Mark One, take a few minutes to run the new utility and in the future, your fiber printing will be more reliable.
If your printer is not networked, instructions on how to install your update can be found here.
모든 블로그와 블로그에 포함된 정보의 저작권은 마크포지드에 있으며, 당사의 서면 허가 없이 어떤 방식으로든 복사, 수정 또는 채택할 수 없습니다. 당사의 블로그에는 당사의 서비스 마크 또는 상표뿐만 아니라 계열사의 상표가 포함될 수 있습니다. 귀하가 당사의 블로그를 사용한다고 해서 당사의 사전 허가 없이 당사의 서비스 마크 또는 상표를 사용할 수 있는 권리나 라이선스가 부여되는 것은 아닙니다. 당사 블로그에서 제공되는 상표 정보는 전문적인 조언으로 간주되어서는 안 됩니다. 당사는 새로운 정보, 후속 이벤트 등을 바탕으로 블로그를 업데이트하거나 수정할 의무가 없습니다.
새로운 정보를 놓치지 마세요
Markforged의 최신 컨텐츠를 편지함으로 받으시려면 구독하십시오.